Previous Sample

Back to Index

Next Sample

wpe81.jpg (4376 bytes)
Wraps per inch
Size Determination
Pictures of the card showing size determination. 

Sample #Number


wpe80.jpg (5451 bytes)
Skein, Size Determination Card and Description Card.

wpe82.jpg (12828 bytes)
Close up of wrapped yarn.

Card that is attached to each skein:

Sample #14
Fiber:  Flax
Weight of Skein:  60 grams

Appl: #1600203
Type: Tow Roving
Length: 140 Yards

Spinning Equipment Used: Flyer Wheel, Ratio 15:1|
Direction of Twist:  S
# of Plies: 2
Finishing:  The yarn was dyed, washed and blocked.  No setting was necessary as the twist was balanced.
Technique: The fiber was spun dry with a short draw from handcarded batts.
Uses:  This strong, supple linen would make lovely woven table mats or pillows.  It could be used for warp or weft because of its strength.  It could be used as the heavier yarn in an overshot pattern.  This yarn is just supple enough to use for knitting a shirt.


Text of Description Card

Preparation for Spinning:  First I pulled off fiber lengths from the roving.  Next I combed through this with woolcarders removing all small nips and short fibers.  I spun from the batts off the carders.

Reason for Choice of this Sample:  This roving was inexpensive, easily obtainable, superior to other tows I found, with fewer nips and  a longer staple.  The very white nature of the roving makes it conducive for dyeing.


Original Fiber Sample in the
Folder with Description Card

wpe3D.jpg (6609 bytes)

wpe83.jpg (17440 bytes)
Enlargement of Sample Skein

All notations that I have added that were not part of the COE are in blue.  These are important as a retrospective on the project. Though the fiber was purchased as roving, it was too lumpy to spin a consistent yarn with.  Carding it again with wool carders allowed me to remove the noil and keep only best and smoothest fiber.
Previous Sample

Back to Index

Next Sample